The realization of a rivertable begins with the establishment of the formwork. screwed and glued. The joints must be perfect to prevent leaks. The surface is smooth, covered with a wax release agent, which will be allowed to dry and glaze by hand. Once the operation is repeated, three times, we will avoid the demolding problems. Then comes the moment of the installation of the wood that we will stick to the clamps on the formwork to prevent it from floating during casting. It is always recommended to apply a first layer of resin with a brush on the surface that will receive it, to avoid bubbles on the one hand, and on the other hand, to allow a better adhesion between the materials. Soloplast casting and embedding resin is weighed. For 30 kilo of resin is added 10 kilo of catalyst. So in a ratio of 3/1. In order to obtain a coloring add a blue coloring paste from the Soloplast range compatible with the resin The slow polymerization time allows the resin to evacuate all its bubbles. It hardens in 48h. The stripping step will allow to appreciate the good application of the wax release agent we applied. Then comes the sanding step. Coarse and gradually thin, we will use abrasive discs of 1000, 2000 and 3000. The sanding will be done on both sides of the plate. To have perfect transparency. The clear and smooth surface, a finishing casting will be made on one side, while we will keep the other brute to the touch. Dusting will be performed, and on both sides still raw a varnish will be applied. Last step, polishing. It will finalize the shine of the table. It remains only to fix the feet and the table will be finalized. I hope you had a good time watching this video, discovering new products. There are still a lot of things to experiment and produce. To continue to follow my projects, I invite you to subscribe to the Youtube channel and follow me on social networks. We meet again very quickly. Ciao!