How To Change Bulbs on Headlights, Fog Lights, Turn Signals 08-14 Buick Enclave


Brought to you by 1AAuto.com, your source
for quality replacement parts and the best service on the Internet. Hi, I’m Mike from 1A Auto. I hope this how-to video helps you out, and
next time you need parts for your vehicle, think of 1AAuto.com. Thanks. In this video, we’re going to show you how
to replace the headlight bulbs as well as the parking light bulbs on this 2010 Buick
Enclave. We show you on the passenger side, but the
driver side is the same procedure. The only tool that you’re going to need for
this is a Phillips screwdriver or a Phillips bit and drill. Inside your wheel well, there are five Phillips
screws, and you can use a pick to just clean out the dirt that gets jammed inside of them. Then, using a Phillips screwdriver or a Phillips
bit and a drill, just remove those five Phillips screws. Pull back the panel and from in here you have
full access to the back of your parking light and, up here, to the back of your headlight. Change the smaller bulbs in the headlight. You just twist them counterclockwise and pull
the socket down. The bulb pulls out. You push your new bulb in and twist the socket
back in to lock it in. Next, we’ll show you the driving light. Out on the white tab, and then push down and
off and then twist the bulb out counterclockwise. This other bulb also just twists out. Pull it down. The old bulb pulls out. The new bulb pushes in. Then just twist the socket back in, clockwise
to lock it. For this bulb, take your new one. Twist it into place clockwise. Then, reconnect the harness. Put the panel back into place and replace
those five Phillips screws. We hope this video helps you out. Brought to you by www.1AAuto.com, your source
for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We’re the company that’s here for you on the
Internet and in person.

23 thoughts on “How To Change Bulbs on Headlights, Fog Lights, Turn Signals 08-14 Buick Enclave

  1. Do you know if the process is the same for HIDS (High Def bulbs)? I have a CXL that comes with $100 HIDS.

  2. I just wanted to thank you so much, you saved me $97.00 from Buick Of Orange Park.Fl .
    They still cheated me on buying the Bulb $11.00 a piece from them since I don't know parts number.
    Your Video just did the job itself. Thank God for you.

  3. Thank you! The bulb cost me $100, other than that about twenty minutes. Would have been at least twice that plus a day without the car. Excellent use of the internet.

  4. Sometimes the Daytime Running Lamp (Socket) burns out also. Be advised of this also.

  5. i guess ill figure this out and post the video for the Regal myself.thanks

  6. Great video. After almost an hour of removing stuff from under the hood I decided to watch your video. How stupid can I be? It was a simple job after watching you.

  7. you didn't even change the headlight like it said in your video

  8. I got two screws that are stripped will not come out any idea on how get them out.

  9. I used a 1" wide scraper between the tabs (watch the wires) to twist out socket. 2728 or 2827 amber bulb. Pick up the bulb first. Would be nice if this video gave bulb part numbers.

  10. I wish my 2013 Enclave just used a Phillips. My screws are star shaped and the headlight bulb my vehicle uses can't be touched with bare hands or dirty gloves.

  11. Hold up there bud there's six screws and btw they are not Philips ?

  12. Nice video. Thanks.
    But easier said than done in sub-FREEZING TEMPS.
    Plastic wheel liner doesn't like to flex much when it's cold.

Leave a Reply

Your email address will not be published. Required fields are marked *